When you’re noticing coolant drips under your tractor or starting to get that sinking feeling when the temperature gauge creeps up during field work, it’s often not the whole water pump that’s failed—just the gasket that seals it to the engine block. This replacement gasket gets your cooling system sealed up tight again without the expense of a complete pump replacement, assuming your pump’s internals are still good.
What You’re Getting
- Precision-cut gasket that matches your water pump’s mounting surface exactly
- Heat-resistant material that handles the temperature cycles of farm work
- Direct replacement that seals coolant passages and bolt holes properly
- Quality construction that prevents weeping and major coolant loss
Built for Real Farm Work
This gasket works with the water pump that serves a wide range of Valtra models from the smaller 300 and 400 series utility tractors up through the powerful 6000 series machines, plus several Massey Ferguson models. Whether your tractor’s pulling implements, running a loader, or powering PTO equipment, proper cooling system sealing keeps everything running at the right temperature.
Made to Last
Farm equipment cooling systems see extreme conditions—from sub-zero starts to summer heat with engines under heavy load. This gasket uses materials that stay flexible through temperature swings and resist degradation from modern coolant additives that can be tough on sealing components.
Installation Notes
You’ll need to drain the cooling system and remove the water pump to replace this gasket. Clean both the pump and engine block mounting surfaces thoroughly—any old gasket material or corrosion will cause leaks. A little gasket sealer on both sides helps ensure a perfect seal, but don’t use too much or it can squeeze into coolant passages.
