When you’re running a loader, adjusting implements, or working hydraulic controls from the cab, you need a cable that responds exactly to your input without delay or sloppiness. This 2.5-meter morse cable gives you that direct connection between your controls and the action happening outside—whether you’re positioning a loader bucket, engaging the PTO, or operating auxiliary hydraulics that power your most important implements.
What You’re Getting
- 2.5 meter length that’s just right for most standard tractor cab-to-implement applications
- Hook-type end fittings that lock on securely but still allow for equipment movement
- Heavy-duty push-pull construction that won’t stretch or bind under load
- Flexible armored outer casing that takes the beating of farm work without kinking
- Smooth inner cable operation that stays responsive through thousands of cycles
Built for Real Farm Work
This cable is the mechanical link that translates your hand movements into precise action at remote valves and controls. You’ll find it connecting loader joysticks to hydraulic spools, three-point controls to lift cylinders, and auxiliary controls to implement functions. The 2.5-meter length hits the sweet spot for most applications—long enough to reach from your cab to the hydraulic block without excess cable cluttering up the space.
Made to Last
Farm equipment cables get cycled constantly and face conditions that would kill lighter-duty cables. This one features a reinforced outer housing that resists crushing while the inner cable glides smoothly in its protective liner. The hook ends provide positive engagement while allowing for the natural articulation that happens as your tractor and implements move through their work.
Installation Notes
Route your cable carefully to maintain at least a 6-inch bend radius—tight corners will reduce cable life and smooth operation. Before you finalize the routing, connect both ends and cycle the control through its full range to make sure you have adequate length without binding. Secure the cable every 12-18 inches with rubber-lined clamps to prevent vibration wear while allowing slight movement.
